Hey Sucker! Distortion

From the vendor

FET preamp into power amp distortion fun, heading into early JCM realms.

There's a lot more gain in this little fella than the small parts count may imply. The FET stage creates remarkably tube-like clipping, giving excellent responsive dynamics. The Power amp takes this deliciously compressed tone and pushes about as hard as it can to create an output your amp will beg for.

Pair it up with a 186,282Mps Drive or a Little Axe for some awesome fun.

The kit is supplied with vertical-mount pots which have round shafts, so you'll need set-screw fitting knobs.

If you want the PCB without parts there's a link for that at the bottom of the page.

Partial kit: PCB, all board-mounted components, pots.

Full kit: As above, plus footswitch and appropriate daughterboard/components for your selected bypass type (see Downloads section for details of those), jack sockets, DC socket, battery snap, hook-up wire, LED.

Enclosure (pre-drilled) is available as an option with full kits, and can take a battery if desired with footswitch positioned 22mm higher, closer to the controls. Knobs are not included.

Builds are only available with full kits including enclosure. Please choose appropriate knobs.

Inspired by: Sucker Punch

Difficulty: Easy

PCB size: 50 x 22mm

Knobs required: 3

Enclosure: 1590B

Direct-Connect compatible (4-way)

If you want the kit pre-built you must add the enclosure option below and select your knobs in the Components section. Check Specials for powder-coated enclosure availability.

Download theINSTRUCTION PDF