125B · 2 knobs
RadianGermanium Boost
Based on the Dallas Rangemaster· 3 other boards clone it
- Category
- Boost· Germanium boost
- Controls
- Boost · Range
- Difficulty
- Easy
- Price
- $12.50in stock
From the vendor
A single-transistor germanium circuit designed to add treble and boost the signal into dark amplifiers to improve the amp’s drive tone.
The Radian Germanium Boost is an adaptation of the Rangemaster Treble Booster produced by Dallas Musical Ltd. of London beginning in 1965. (Dallas would later merge with Arbiter Electronics to form Dallas-Arbiter, best known for the Fuzz Face.)
The Rangemaster was originally designed to add treble content to somewhat dark British amplifiers such as the Vox AC30, but it took on a life of its own in the hands of Brian May, Tony Iommi, Rory Gallagher, and several other highly-regarded guitarists of that era.
The original Rangemaster was not actually a pedal, but rather a freestanding unit that was intended to sit on top of the amplifier. The unit was bypassed using a slide switch on the front of the unit, so it wasn’t practical to turn it on and off while playing, and it was intended for use as an always-on tone enhancer.
The Radian is a pedal conversion of the Rangemaster with one big enhancement: a voltage inverter has been added which allows it to be powered with a standard center-negative adapter while maintaining the positive-ground operation of the original. The PCB also includes a biasing trim pot so you can dial in a perfect bias without having to swap out resistors.
The other enhancement is a “Range” toggle switch that lets you choose between a treble boost, mid boost, or full-range boost. The treble-boost effect in this circuit is achieved by first cutting low frequencies, then boosting the whole signal so that the lows are restored to normal and the treble frequencies are emphasized. This toggle switch lowers the low-frequency cutoff point so that less of the signal is cut and more is boosted.
Schematic
The schematic is in the vendor's build document, page 5. Open the build document. No KiCad fragment has been drawn for this circuit yet.
Parts list 29 rows
Report a wrong parse| Ref | Value | Normalized | Type | Notes |
|---|---|---|---|---|
| Resistors 5 | ||||
| R1 | 470k | 470k | Metal film resistor, 1/4W | |
| R2 | 68k | 68k | Metal film resistor, 1/4W | |
| R3 | 1k | 1k | Metal film resistor, 1/4W | |
| RPD | 1M | 1M | Metal film resistor, 1/4W | Input pulldown resistor. |
| LEDR | 10k | 10k | Metal film resistor, 1/4W | LED current-limiting resistor. Adjust value to change LED brightness. |
| Capacitors 10 | ||||
| C1 | 4n7 | 4.7n | Film capacitor, 7.2 x 2.5mm | |
| C2 | 6n8 | 6.8n | Film capacitor, 7.2 x 2.5mm | Sets the frequency of the Range switch. See build notes. |
| C3 | 22n | 22n | Film capacitor, 7.2 x 2.5mm | Sets the frequency of the Range switch. See build notes. |
| C4 | 47uF | 47u | Electrolytic capacitor, 5mm | |
| C5 | 10n | 10n | Film capacitor, 7.2 x 2.5mm | |
| C6 | 100uF | 100u | Electrolytic capacitor, 6.3mm | |
| C7 | 10uF | 10u | Electrolytic capacitor, 5mm | |
| C8 | 47uF | 47u | Electrolytic capacitor, 5mm | |
| C9 | 100n | 100n | MLCC capacitor, X7R | |
| C10 | 100n | 100n | MLCC capacitor, X7R | |
| Diodes 2 | ||||
| Z1 | 1N4742A | 1N4742A | Zener diode, 12V, DO-41 | |
| D1 | 1N5817 | 1N5817 | Schottky diode, DO-41 | |
| Transistors 1 | ||||
| Q1 | Germanium | GERMANIUM | Germanium transistor, PNP | Recommended to buy a selected Rangemaster transistor. See build notes. |
| ICs 1 | ||||
| IC1 | TC1044SCPA Volt | TC1044SCPA VOLT | age inverter, DIP8 | |
| Trimmers 1 | ||||
| BIAS | 5k | 5k | Trimmer, 10%, 1/4" | |
| Switches 1 | ||||
| FSW | 3PDT | 3PDT | Stomp switch, 3PDT | |
| LEDs 1 | ||||
| LED | 5mm | 5MM | LED, 5mm, red diffused | |
| Jacks & sockets 5 | ||||
| Q1-S | TO-5 socket | TO-5 SOCKET | Transistor socket, TO-5 | |
| IC1-S | DIP-8 socket | DIP-8 SOCKET | IC socket, DIP-8 | |
| IN | 1/4" stereo | 1/4" STEREO | 1/4" phone jack, closed frame | Switchcraft 112BX or equivalent. |
| OUT | 1/4" mono | 1/4" MONO | 1/4" phone jack, closed frame | Switchcraft 111X or equivalent. |
| DC | 2.1mm | 2.1MM | DC jack, 2.1mm panel mount | Mouser 163-4302-E or equivalent. |
| Hardware 2 | ||||
| BATT | Battery snap | BATTERY SNAP | 9V battery snap | Optional. Use the soft plastic type—the hard-shell type will not fit. |
| ENC | 125B | 125B | Enclosure, die-cast aluminum | Can also use a Hammond 1590N1. |
Other boards based on the Dallas Rangemaster
- Radian (Legacy) Aion FX · 1590B
- FuzzPup RangeMaster Fuzz Dog · 1590A · £21.60
- RangeMaster PCBWay: Glory to Ukraine