Parts · ICs
TLC2274
Quad CMOS-Input Op-Amp DIP-14 / SOIC-14.1 circuit uses this part.
Datasheet · from ti.com
Substitutes same socket
Parts that fit the same socket: the same function, pin count and pinout. The figures are read off each part's datasheet (this one's from page 11), typical where the sheet gives a typical value, otherwise the maximum. Closest first; the last column says what differs. A different part can change the sound, and a circuit may lean on one particular figure, so read the build document's notes before you swap.
This part
| Part | Input | Supply | GBW | Slew | Noise | Iq | Boards |
|---|---|---|---|---|---|---|---|
| TLC2274 | CMOS, RR out | 4.4–16 V | 2.25 MHz | 3.6 V/µs | 9 nV | 1.2 mA | 1 |
CMOS rail-to-rail-output quad limited to 16 V total.
Fits the same socket
| Part | Input | Supply | GBW | Slew | Noise | Iq | Boards | Differs |
|---|---|---|---|---|---|---|---|---|
| LMC660CN | CMOS, RR out | 4.75–15.5 V | 1.4 MHz | 1.1 V/µs | 22 nV | 0.4 mA | 4 | CMOS quad limited to 15.5 V total; rail-to-rail output and an input range that includes ground. |
| TLC27M4AIN | CMOS | 3–16 V | 1.1 MHz | 4.5 V/µs | 32 nV | 0.06 mA | 8 | Low-power CMOS quad limited to 16 V; the input range includes the negative rail (single-supply friendly). |
| TL974 | RR out | 2.7–12 V | 10.6 MHz | 2.48 mA | 1 | much faster, may oscillate in a slow part's place. Low-noise quad (4.4 nV/√Hz at 100 kHz) limited to 12 V total; it will not survive an 18 V rail. | ||
| MC33179 | bipolar | 4–36 V | 5 MHz | 2 V/µs | 7.5 nV | 0.425 mA | 2 | bipolar input. Quad version of the MC33178 in the standard quad pinout. |
| TL064 | JFET | 10–30 V | 1 MHz | 3.5 V/µs | 30 nV | 0.2 mA | 17 | JFET input; rated from 10 V. Low-power JFET quad at 200 µA per amplifier. |
| LF347 | JFET | 7–36 V | 3 MHz | 13 V/µs | 18 nV | 2 mA | 20 | JFET input. JFET quad; common-mode range must stay 4 V inside each rail. |
| TLC2264 | CMOS, RR out | 4.4–16 V | 0.73 MHz | 0.55 V/µs | 12 nV | 0.21 mA | 3 | much slower. CMOS rail-to-rail-output quad limited to 16 V total. |
| 3403 | bipolar | 5–30 V | 1 MHz | 0.6 V/µs | 0.7 mA | 17 | bipolar input; much slower. 741-class quad that runs from a single supply; the input range includes the negative rail and the output has a class AB stage. | |
| LM348 | bipolar | 8–36 V | 1 MHz | 0.5 V/µs | 0.6 mA | 2 | bipolar input; much slower. Four 741-class amplifiers in the LM324/TL074 pinout. | |
| TL074 | JFET | 4.5–40 V | 5.25 MHz | 20 V/µs | 37 nV | 1.4 mA | 315 | JFET input. JFET input; inputs must stay 4 V above the negative rail. |
| Faceplate | Circuit | Based on | Category | Vendor | Box | Knobs | Price | BOM |
|---|---|---|---|---|---|---|---|---|
| Wally II 2N3904 · BS170 · BS250 · TLC2274 Spaceman Effects Apollo VIIb · 125B | Spaceman Effects Apollo VIIb | Overdrive | Dead End FX | 125B | 3 | $12.00 | 46 |