Parts · ICs
LMC660CN
Quad CMOS-Input Op-Amp DIP-14.4 circuits use this part.
Datasheet · from ti.com
Substitutes same socket
Parts that fit the same socket: the same function, pin count and pinout. The figures are read off each part's datasheet (this one's from page 6), typical where the sheet gives a typical value, otherwise the maximum. Closest first; the last column says what differs. A different part can change the sound, and a circuit may lean on one particular figure, so read the build document's notes before you swap.
This part
| Part | Input | Supply | GBW | Slew | Noise | Iq | Boards |
|---|---|---|---|---|---|---|---|
| LMC660CN | CMOS, RR out | 4.75–15.5 V | 1.4 MHz | 1.1 V/µs | 22 nV | 0.4 mA | 4 |
CMOS quad limited to 15.5 V total; rail-to-rail output and an input range that includes ground.
Fits the same socket
| Part | Input | Supply | GBW | Slew | Noise | Iq | Boards | Differs |
|---|---|---|---|---|---|---|---|---|
| TLC2264 | CMOS, RR out | 4.4–16 V | 0.73 MHz | 0.55 V/µs | 12 nV | 0.21 mA | 3 | CMOS rail-to-rail-output quad limited to 16 V total. |
| TLC2274 | CMOS, RR out | 4.4–16 V | 2.25 MHz | 3.6 V/µs | 9 nV | 1.2 mA | 1 | draws 1.2 mA per amplifier. CMOS rail-to-rail-output quad limited to 16 V total. |
| LF444 | JFET | ?–36 V | 1 MHz | 1 V/µs | 35 nV | 0.15 mA | 4 | JFET input. Low-power JFET quad at about 150 µA per amplifier. |
| 3403 | bipolar | 5–30 V | 1 MHz | 0.6 V/µs | 0.7 mA | 17 | bipolar input. 741-class quad that runs from a single supply; the input range includes the negative rail and the output has a class AB stage. | |
| LM324 | bipolar | 3–30 V | 1.2 MHz | 0.5 V/µs | 35 nV | 0.35 mA | 100 | bipolar input. Input range includes the negative rail and the output nears ground, but it is slow and shows crossover distortion. |
| LM348 | bipolar | 8–36 V | 1 MHz | 0.5 V/µs | 0.6 mA | 2 | bipolar input. Four 741-class amplifiers in the LM324/TL074 pinout. | |
| TLC27M4AIN | CMOS | 3–16 V | 1.1 MHz | 4.5 V/µs | 32 nV | 0.06 mA | 8 | Low-power CMOS quad limited to 16 V; the input range includes the negative rail (single-supply friendly). |
| TL064 | JFET | 10–30 V | 1 MHz | 3.5 V/µs | 30 nV | 0.2 mA | 17 | JFET input; rated from 10 V. Low-power JFET quad at 200 µA per amplifier. |
| JRC2902 | bipolar | 3–32 V | 0.5 MHz | 0.5 V/µs | 0.25 mA | 2 | bipolar input. LM324-class single-supply quad with crossover distortion; the DIP14 (NJM2902N) is listed as discontinued. | |
| MC33179 | bipolar | 4–36 V | 5 MHz | 2 V/µs | 7.5 nV | 0.425 mA | 2 | bipolar input. Quad version of the MC33178 in the standard quad pinout. |
| Faceplate | Circuit | Based on | Category | Vendor | Box | Knobs | Price | BOM |
|---|---|---|---|---|---|---|---|---|
| Grimafuzz LMC660CN · LT1054 · TL072 · TL074 1590BBS | — | Fuzz | Dead End FX | 1590BBS | 7 | $15.00 | 52 | |
| Pllain 40106N · 4017N · 4046N · CD40106 1590XX | — | Fuzz | Dead End FX | 1590XX | 11 | $20.00 | 67 | |
| Pllone 40106N · 4017N · 4046N · CD40106 Schumann PLL | Schumann PLL | Fuzz | Dead End FX | — | 14 | $25.00 | 79 | |
| Deadend Fx Grimmafuzz / Schumann PLL fuzz section Vero24×24 Unverified 7660S · ICL7660S · LMC660CN · TL072 Deadend Fx Grimmafuzz / Schumann PLL fuzz section | Deadend Fx Grimmafuzz / Schumann PLL fuzz section | Fuzz | Dirtbox Layouts | — | 7 | — | 33 |