Akashic Guitar effects circuit lookup
VOLUMEABUSESPARKLE

Enclosure not stated · 3 knobs

Tagboard Effects

Mictester - Silicon TonebenderVerified

Based on the MicTester Silicon Tonebender· 3 other boards clone it

Category
Fuzz
Controls
Volume · Abuse · Sparkle
Build
Vero· 22×10· 13 cuts, 3 links
Layout
Verified · Tagboard Effects marks it as built and working
Tags
Fuzz, Mictester

From the post

Found this while searching for some schematics for Silicon Tonebenders I came across it on revolutiondeux. Miro posted a layout awhile ago for the Hot Silicon, which is pretty much the same, the difference being the trimmer off the gain control (abuse) which lets you set the gain rather then having a set resistor. Since my layout different then his, and the added trimmer I figured it was worth adding.

Here's mictester's advice on tweaking:

"Adjustment: set the 1k "Abuse" pot halfway. Play though it, and adjust 5k preset until "gating" just stops. That's it!

You'll find that it has plenty of output, that the "Abuse" control gives a good range of colour, the "Sparkle" control has a very wide range and the sound is remarkably reminiscent of early Jeff Beck (certainly not a bad thing!).

Possible mods:

Put small value capacitors from base to collector of the middle two transistors - start with 47pF. This "smooths out" the sound a lot, but reduces the treble available.

If you have radio interference, put 100pF from base of the first transistor to ground.

Experiment with the capacitor values in the tone control - the 8n2 could go as low as 3n3, which would give a ridiculous range of treble control!

Increase the value of the 47k feedback / bias resistor - try as high as 470k. The gain will rise, the touch sensitivity will disappear, and it will become a high gain screaming monster! "

Schematic

This is a board layout, a drawing of where each part goes, and the post may link the schematic it was drawn from. Open the layout at Tagboard Effects. No KiCad fragment has been drawn for this circuit yet.

Parts list 20 rows

Report a wrong parse

Got parts in a drawer? See what you can build with them.

RefValueNormalizedTypeNotes
Resistors 8
×610k10kread from the layout by eye
×1150k150kread from the layout by eye
×11M1Mread from the layout by eye
×122k22kread from the layout by eye
×11k1kread from the layout by eye
×147k47kread from the layout by eye
×1100r100read from the layout by eye
×12.2k2.2kread from the layout by eye
Capacitors 6
×3100nF100nread from the layout by eye
×110nF10nread from the layout by eye
×18.2nF8.2nread from the layout by eye
×147uF47uelectrolytic; read from the layout by eye
×110uF10uelectrolytic; read from the layout by eye
×14.7uF4.7uelectrolytic; read from the layout by eye
Transistors 1
×42N50892N5089Q1-Q4; read from the layout by eye
Potentiometers 3
VolumeA100KA100kPotentiometerread from the layout by eye
AbuseB1KB1kPotentiometerread from the layout by eye
SparkleB50KB50kPotentiometerread from the layout by eye
Trimmers 1
×15k5kread from the layout by eye
Switches 1
FatSPSTSPSTread from the layout by eye

Other boards based on the MicTester Silicon Tonebender