Enclosure not stated · 3 knobs
Bearfoot Dyna Red DistortionVerified
Based on the BearFoot FX Dyna Red Distortion· 3 other boards clone it
- Category
- Distortion
- Build
- Vero· 20×12
- Layout
- Verified · Tagboard Effects marks it as built and working
- Tags
- BJF/MP, Distortion
From the post
Info from the builder:
The Dyna Red is a classic distortion that immediatley sounds familiar. What sets the DRD apart is that it also manages to mimic the FEEL of a healthy plexibasketweaver.
While it is known for its crunchy classic rock distortion - it also has a very tasty 'just above driven' sound that really shows off its dynamic low dirt capabilities.
the DRD can be safely used between 5 and 15 v. (lower the voltage for easier saturation and raise it to tighten up the response and add headroom)
This has been verified by muhd85:
Schematic
This is a board layout, a drawing of where each part goes, and the post may link the schematic it was drawn from. Open the layout at Tagboard Effects. No KiCad fragment has been drawn for this circuit yet.
Parts list 26 rows
Report a wrong parseGot parts in a drawer? See what you can build with them.
Check before you build · 1 value the reader of this layout was not sure of
- 14K7 at the far left of the board: printed clearly, unusual value
| Ref | Value | Normalized | Type | Notes |
|---|---|---|---|---|
| Resistors 9 | ||||
| ×1 | 14K7 | 14.7k | read from the layout by eye | |
| ×2 | 1M | 1M | read from the layout by eye | |
| ×1 | 360K | 360k | read from the layout by eye | |
| ×2 | 1K | 1k | read from the layout by eye | |
| ×2 | 3K | 3k | read from the layout by eye | |
| ×2 | 47K | 47k | read from the layout by eye | |
| ×1 | 10K | 10k | read from the layout by eye | |
| ×1 | 47R | 47 | read from the layout by eye | |
| ×1 | 3K6 | 3.6k | read from the layout by eye | |
| Capacitors 8 | ||||
| ×2 | 47n | 47n | read from the layout by eye | |
| ×1 | 100p | 100p | read from the layout by eye | |
| ×1 | 220p | 220p | read from the layout by eye | |
| ×2 | 22n | 22n | read from the layout by eye | |
| ×1 | 100n | 100n | swap for 470n for mid boost; read from the layout by eye | |
| ×1 | 100u | 100u | electrolytic; read from the layout by eye | |
| ×1 | 22u | 22u | electrolytic; read from the layout by eye | |
| ×2 | 1u | 1u | electrolytic; read from the layout by eye | |
| Diodes 2 | ||||
| D3 | 1N4001 | 1N4001 | read from the layout by eye | |
| D4 | 1N4001 | 1N4001 | read from the layout by eye | |
| Transistors 1 | ||||
| Q1 | 2N5458 | 2N5458 | JFET; read from the layout by eye | |
| ICs 1 | ||||
| ×1 | CA3130 | CA3130 | read from the layout by eye | |
| Potentiometers 3 | ||||
| Dist | A500K | A500k | Potentiometer | read from the layout by eye |
| Treble | B50K | B50k | Potentiometer | read from the layout by eye |
| Volume | B50K | B50k | Potentiometer | read from the layout by eye |
| LEDs 2 | ||||
| D1 | red 3mm | RED 3MM | read from the layout by eye | |
| D2 | red 3mm | RED 3MM | read from the layout by eye | |
Other boards based on the BearFoot FX Dyna Red Distortion
- Dyna Red Distortion PCBWay: Glory to Ukraine
- Dynasty Distortion PedalPCB · 125B · $8.00
- Bearfoot FX Dyna Red Distortion Revolution Deux