Enclosure not stated · 1 knob
Split 'n' BlendVerified
Based on the Split 'n Blend· 1 other board clones it
From the post
I like these little "utility boxes"
(Please take note! This circuit will not work as a blend for pedals that invert the signal polarity (or phase). For a few examples of such pedals; the likes of Dyna Compressor/Ross Comp and their derivatives and Marshall Bluesbreaker among others. The symptom of inverted signal polarity (phase) will be significant drop in level when the blend pot is set near its middle position. This is caused by two polarity phases cancelling each other out. If you need a way to control the phase, then you need to address this accordingly.)
Schematic
This is a board layout, a drawing of where each part goes, and the post may link the schematic it was drawn from. Open the layout at Tagboard Effects. No KiCad fragment has been drawn for this circuit yet.
Parts list 6 rows
Report a wrong parseGot parts in a drawer? See what you can build with them.
| Ref | Value | Normalized | Type | Notes |
|---|---|---|---|---|
| Resistors 2 | ||||
| ×2 | 4K7 | 4.7k | read from the layout by eye | |
| ×1 | 2M2 | 2.2M | read from the layout by eye | |
| Capacitors 2 | ||||
| ×3 | 100n | 100n | read from the layout by eye | |
| ×1 | 100u | 100u | electrolytic; read from the layout by eye | |
| Transistors 1 | ||||
| ×2 | BF245 | BF245 | JFET; legend: If you don't have BF245 JFETs, try 2N5457 or J201; read from the layout by eye | |
| Potentiometers 1 | ||||
| Blend | B100K | B100k | Potentiometer | read from the layout by eye |
Other boards based on the Split 'n Blend
- Split 'n Blend Effects Layouts (blog) · 1590A