Enclosure not stated · 2 knobs
Lovepedal Karl Fuzz (2-knob)
Based on the Lovepedal Karl Fuzz· 5 other boards clone it
- Category
- Fuzz
- Price
- see vendor
- Also as
- Vero layout · from Revolution Deux
- Tags
- freestompboxes.org trace
From the vendor
The older two-knob Karl: a 2N5089 gain stage, with a 5KB Intensity pot at the input, drives a 2N3906/2N3904 'non-selective frequency tripler' pair, followed by a 1N4148/BAT46 diode clipper and the Volume pot. The post identifies it as an adaptation of Tim Escobedo's Tripple Fuzz and describes it as sweet at low gain with octave and ring-mod tones at higher gain.
The post says the 1M pulldown at the input is not needed, since it sits in parallel with the 5KB Intensity pot. The post says the two power filter capacitors are unneeded and the 47u can be left out. The newer three-knob Karl adds a tone control; the post suggests a 10n-22n capacitor to ground through a B47K pot just after the last output capacitor, before the Volume pot, or a Big Muff style tone stack.
Schematic
The schematic is in the post. Open it at Revolution Deux. No KiCad fragment has been drawn for this circuit yet.
Parts list 21 rows
Report a wrong parseGot parts in a drawer? See what you can build with them.
Check before you build · 1 value the reader of this schematic was not sure of
- The vero layout's parts list differs from the schematic: it has a 100n ceramic and 220u filter capacitor where the schematic has 47u and 100u, adds a 1N4001 (D1) and an LED resistor, and lists the clipping diodes as BAT46 and 1N914.
| Ref | Value | Normalized | Type | Notes |
|---|---|---|---|---|
| Resistors 7 | ||||
| R1 | 3.3M | 3.3M | Q1 collector-base; read from the schematic by eye | |
| R2 | 1K | 1k | Q1 emitter; read from the schematic by eye | |
| R3 | 3.3K | 3.3k | Q1 collector; read from the schematic by eye | |
| R4 | 330 | 330 | power filter; read from the schematic by eye | |
| R5 | 10K | 10k | Q2 emitter; read from the schematic by eye | |
| R6 | 10K | 10k | Q3 emitter; read from the schematic by eye | |
| R7 | 1M | 1M | input pulldown; read from the schematic by eye | |
| Capacitors 7 | ||||
| C1 | 22u | 22u | electrolytic, Q1 emitter bypass; read from the schematic by eye | |
| C2 | 47n | 47n | read from the schematic by eye | |
| C3 | 220n | 220n | read from the schematic by eye | |
| C4 | 390p | 390p | read from the schematic by eye | |
| C5 | 220n | 220n | read from the schematic by eye | |
| C6 | 47u | 47u | electrolytic, power filter; read from the schematic by eye | |
| C7 | 100u | 100u | electrolytic, power filter; read from the schematic by eye | |
| Diodes 2 | ||||
| D2 | BAT46 | BAT46 | clipping; read from the schematic by eye | |
| D3 | 1N4148 | 1N4148 | clipping; read from the schematic by eye | |
| Transistors 3 | ||||
| Q1 | 2N5089 | 2N5089 | read from the schematic by eye | |
| Q2 | 2N3904 | 2N3904 | read from the schematic by eye | |
| Q3 | 2N3906 | 2N3906 | read from the schematic by eye | |
| Potentiometers 2 | ||||
| Intensity | B5K | B5k | Potentiometer | read from the schematic by eye |
| Volume | B500K | B500k | Potentiometer | read from the schematic by eye |
Other boards based on the Lovepedal Karl Fuzz
- Lovepedal Karl Fuzz Dirtbox Layouts
- Karlito Loves Fuzz Fuzz Dog · 1590B · £27.60
- Karl PCBWay: Glory to Ukraine
- Kalle PedalPCB · 125B · $8.00
- Lovepedal Karl Tagboard Effects