SoopaCharged Overdrive

From the vendor

Beautiful little high gain drive pedal to really push your amp. The cascaded MosFet gain stages give a huge amount of breakup without the need for diode clipping, while keeping noise to a minimum. The contour control resembles an amp presence control in operation, dictating the amount of punch you're throwing down the cable. Though not officially touted as such, I'd say this is the right direction to be looking if you want to fill the Orange amp-emulation gap. Not much else to tell you other than it'd look good in an orange enclosure. The kit is supplied with vertical-mount pots which have round shafts, so you'll need set-screw fitting knobs. If you want the PCB without parts there's a link for that at the bottom of the page. Partial kit: PCB, all board-mounted components, pots. Full kit: As above, plus footswitch and appropriate daughterboard/components for your selected bypass type (see Downloads section for details of those), jack sockets, DC socket, battery snap, hook-up wire, LED. Enclosure (pre-drilled) is available as an option with full kits, and can take a battery if desired with footswitch positioned 22mm higher, closer to the controls. Knobs are not included. Builds are only available with full kits including enclosure and vertical-mount pots. Please choose appropriate knobs. Inspired by: Supercharged Overdrive Difficulty: Medium PCB size: 50 x 40mm Knobs required: 3

Enclosure: 1590B Direct-Connect compatible (4-way) Download INSTRUCTION PDF