Enclosure not stated · 9 knobs
Butcher Pedals Pistol Slapper
Based on the Butcher Pedals Pistol Slapper· 1 other board clones it
From the post
Schematic is avaiable HERE.
Schematic
This is a board layout, a drawing of where each part goes, and the post may link the schematic it was drawn from. Open the layout at Dirtbox Layouts. No KiCad fragment has been drawn for this circuit yet.
Parts list 9 rows
Report a wrong parseGot parts in a drawer? See what you can build with them.
Only the parts the layout names in its legend are listed: the active parts and the pots. The resistor and capacitor values are printed on the parts in the drawing.
ocr read from an image · sch paired from the schematic · fixed corrected by hand. Check marked values against the build document.
| Ref | Value | Normalized | Type | Notes |
|---|---|---|---|---|
| Diodes 3 | ||||
| D1 | 1N4148ocr | 1N4148 | from the layout legend | |
| D2 | 1N4148ocr | 1N4148 | from the layout legend | |
| D3 | 1N5817ocr | 1N5817 | from the layout legend | |
| ICs 2 | ||||
| IC1 | 1458ocr | 1458 | from the layout legend | |
| IC2 | ICL7660Socr | ICL7660S | from the layout legend | |
| Potentiometers 4 | ||||
| Drive | B25Kocr | B25k | from the layout legend | |
| Mid | C10Kocr | C10k | from the layout legend | |
| Bass | C10Kocr | C10k | from the layout legend | |
| Level | A100Kocr | A100k | from the layout legend | |
Other boards based on the Butcher Pedals Pistol Slapper
- Terrahawk Dead End FX · 1590BBS · $15.00