Enclosure not stated
Echoplex EP-3 Preamp
Based on the Maestro Echoplex EP-3 Preamp· 6 other boards clone it
From the post
About the part selection – 22n’s and 100n is sized to tropical fish caps to be used. For 10uf’s 25v BC Electronic caps make perfect fit. MAX1044 can’t take more than 10v voltage input, so forget about 12vdc power supply. You may use other voltage doubler chip like the LTC1054. I’m going to add another cap and diode to make it close to 24v with popular 9VDC source when I’ll find spare minute. JFET marked in the layout is picked up just for low noise. No idea how cute this sounds in this circuit. I guess I’ll make some experiments with other JFET’s to pick up the best one. At this point of time it’s not verified, I hope it works…
Schematic
This is a board layout, a drawing of where each part goes, and the post may link the schematic it was drawn from. Open the layout at turretboard.org. No KiCad fragment has been drawn for this circuit yet.
Parts list 0 rows
Report a wrong parseNo parts could be read from this layout; the values are printed on the parts in the drawing.
Other boards based on the Maestro Echoplex EP-3 Preamp
- Ares Aion FX · 125B · $12.50
- Ares (Legacy) Aion FX · 1590B
- Echoplex EP-3 Pre Amp / Aion Ares Dirtbox Layouts
- Multiplex Jr. Delay 1776 Effects · 1590B · $10.00
- E.P.3.0 Five Cats Pedals · 1590B · £4.50
- EP3 Preamp PCBWay: Glory to Ukraine