Akashic Guitar effects circuit lookup

Enclosure not stated

Tagboard Effects

Providence Stampede OD SOV-2Verified

Based on the Providence SOV-2 Stampede OD· 2 other boards clone it

Category
Overdrive
Build
Vero· 9×11· 4 cuts, 1 links
Layout
Verified · Tagboard Effects marks it as built and working
Tags
Charge pump, Overdrive

From the post

And this is the one I did the bipolar voltage converter for! :o)

This pedal uses a 9V supply which is then converted to +/-15V using a 5V regulator into an expensive NMA0515SC 5V to +/-15V converter, plus a couple of inductors which is another unusual component for us to use. So I preferred the idea of using components I was more familiar with and which could be obtained at a lower cost and in any quantity.

So you're going to need the bipolar converter layout I did from yesterday. This will take you a bit above the +/-15V used by the original which may give you a little more headroom, but if you want to drop it a bit further consider putting a polarity protection diode in series with the 9V supply to the charge pump. That will drop the voltage around 0.7V before conversion to get things a bit lower. I think if you do that and use 1N4001 instead of 1N5817 in the charge pump you'll be very close to the required number. Or just have a bit of extra headroom, it's up to you.

You can either make it all on one board, or I reckon it would be easier to keep the converter on a separate daughter board which can be tucked away somewhere in the box.

The diodes are unknown, here is a pic posted by Olof who posted the schematic on Freestompboxes if anyone has any ideas:

It has been suggested that the red and blue one may be a 1S1588, which I think is one of the unobtainium diodes in the Analogman King of Tone. And the other has been suggested to be a 1N4249. If you can get them to try then all the better, if not then just use a 1N4148 and 1N4001 combination which I'm sure will get you 99% there if not all the way. Or experiment and let us all know how it turns out! :o)

Manufacturers description:

A wide dynamic range of overdrive sounds. The Providence SOV-2 Stampede OD pedal is designed to deliver natural overdrive without obscuring the inherent characteristics and tone of the guitar being used. It features a special bipolar power supply that powers the internal circuitry with boosted voltage, providing a wider dynamic range than possible with conventional 9-volt powered overdrives. For singing lead tones and solid, chunky rhythms, there's nothing like the SOV-2 Stampede OD.

Schematic

This is a board layout, a drawing of where each part goes, and the post may link the schematic it was drawn from. Open the layout at Tagboard Effects. No KiCad fragment has been drawn for this circuit yet.

Parts list 8 rows

Report a wrong parse

Got parts in a drawer? See what you can build with them.

RefValueNormalizedTypeNotes
Capacitors 2
×310u10uelectrolytic; read from the layout by eye
×3100u100uelectrolytic; read from the layout by eye
Diodes 5
D11N58171N5817read from the layout by eye
D21N58171N5817read from the layout by eye
D31N58171N5817read from the layout by eye
D41N58171N5817read from the layout by eye
D51N58171N5817read from the layout by eye
ICs 1
ICLT1054LT1054read from the layout by eye

Other boards based on the Providence SOV-2 Stampede OD