Stoner NFT

From the vendor

Project overview

Imagine that you’ve found an NFT. Not just any NFT, but one created in the 70s that gives you the power to create earthquakes within your eyesight. The Stoner NFT is exactly that – it turns everything on your way into rubble… and it’s not a bubble! This pedal is worthy of a Klon Centaur price, but today you can create your own copy and just watch the stonks go through the roof!

Introduction

The Stoner NFT is based on the legendary 70s Ampeg sound that we all know and love. The tubes were replaced by JFET transistors for minimum size and maximum tone. This little beast runs on 18 volts internally through a charge pump to provide extra headroom.

The circuit comes with 4 knobs and a switch. GAIN, VOL, TREB and BASS are the knobs and STONES/STONER is the switch’s name. GAIN is the pot that allows you to dial in the amount of saturation in your signal. With VOL you can set how loud the pedal will get. TREB and BASS are the EQ section of the pedal, giving you control over high and low frequencies, respectively. The cherry on the top is the STONES/STONER switch. This selector is an extension to the GAIN pot, and it lets you switch from the verge of breakup tone to a near-fuzz experience with a single flip.

Don’t miss out on the next big thing. You don’t need to sell your house, car, or a kidney to invest this time – an iron, a few components, and a bit of solder is all it takes for your portfolio to go to the moon!

Controls

• Potentiometers

• Bass

• Gain

• Treb

• Vol

Switches

• Stoner-SW

For further analysis on this circuit take a look at this thread on DIY Stomp Boxes Forum.

For any technical questions regarding this build don’t forget to check out our Facebook Group and our forum at Free Stomp Boxes.

Stoner NFT – Building Docs

Stoner NFT – Drilling template