Rectifier Box

From the vendor

Project overview

The Rectifier Box is my first attempt to capture the essence of the Mesa Boogie’s Throttle box, one of the best High gain distortions I ever heard, with a really interesting Mid-cut section.

Introduction

Put the Rectifier Box distortion pedal before your amplifier and get ready for pure aggressiveness and power!

This is a difficult to build High gain Drive. With an average availability of components. Just take special notice that this project works with a 220uH inductor.

• Works with two TL074 and one JRC 4558

• 3pdt Switch on board

• 2 DPDT, Input selector, and Mid-cut EQ.

• A very useful mid-control pot and switch based on an inductor.

Controls

• Gain

• Volume

• Tone

• Mid-cut

• Toggle to choose the input mode

• Toggle to enable the Mids mode

For further analysis on this circuit take a look at this thread on Free Stomp Boxes Forum.

For any technical questions regarding this build don’t forget to check out our Facebook Group and our forum at Free Stomp Boxes.

Rectifier Box 2v – Building Docs

Rectifier Box 1v – Building Docs

Rectifier Box – Drilling Template

Rectifier Box – Drilling Templates V2

Important building notes

This item corresponds to one PCB of the “Rectifier Box.” You supply the components, check the Building docs below for the shopping list.

Inductor 220Mu:

https://cz.mouser.com/ProductDetail/710-7447221221

https://cz.mouser.com/ProductDetail/710-7447221221

On this drilling template, I made some changes to make it fit properly in a 1590BB enclosure. It fits super tight, and I replaced the onboard pots for regular ones. For the DC jack, I recommend using the smaller ones.

https://pcbguitarmania.com/wp-content/uploads/2018/03/mesa-project.mp4