125B · 6 knobs
Paulo Gilberto
Based on the JHS PG-14· 1 other board clones it
- Category
- Distortion· Overdrive, fuzz, distortion
- Controls
- Vol · Sweep · Drive · Mid · Push · Tone
- Difficulty
- Advanced
- Price
- €11.90out of stock
Heads up Builders widely report inconsistent quality from PCB Guitar Mania boards, and whether a given board works is a gamble. Read recent forum reports before ordering.
From the vendor
Project overview
This drive is one of those very few pedals that sounds fresh, although this circuit’s architecture is basically a JHS Haunting mids +JHS Super bolt.
Oh man, this combination is a total killer, nailing every pallet of overdrive to saturated sputter fuzz tones.
Introduction
A unique distortion circuit designed explicitly to Paul’s specifications, and oh man, it shows. Paulo Gilberto can emulate a pushed tube amplifier’s touch, feel, and sensitivity thanks to its FET-based distortion engine. This board will give you the dynamics and tone of a loud stadium level amplifier at low/moderate volume levels!
Controls
Potentiometers
• Drive
• MID
• PUSH
• TONE
• VOL
• SWEEP
For any technical questions regarding this build don’t forget to check out our Facebook Group and our forum at Free Stomp Boxes.
Paulo Gilberto – Building Docs
Paulo Gilberto – Drilling template
Schematic
The schematic is in the vendor's build document, page 5. Open the build document. No KiCad fragment has been drawn for this circuit yet.
Parts list 68 rows
Report a wrong parse| Ref | Value | Normalized | Type | Notes |
|---|---|---|---|---|
| Resistors 25 | ||||
| R1 | 1m | 1M | ||
| R2 | 470k | 470k | ||
| R3 | 10k | 10k | ||
| R4 | 4k7 | 4.7k | ||
| R5 | 22k | 22k | ||
| R6 | 3k3 | 3.3k | ||
| R7 | 22k | 22k | ||
| R8 | 5k6 | 5.6k | ||
| R9 | 5k6 | 5.6k | ||
| R10 | 6k8 | 6.8k | ||
| R11 | 3k3 | 3.3k | ||
| R12 | 4k7 | 4.7k | ||
| R13 | 4k7 | 4.7k | ||
| R14 | 1m | 1M | ||
| R15 | 1k5 | 1.5k | ||
| R16 | 470k | 470k | ||
| R17 | 2k7 | 2.7k | ||
| R18 | 120k | 120k | ||
| R19 | 470k | 470k | ||
| R20 | 330r | 330 | ||
| R21 | 12k | 12k | ||
| R22 | 12k | 12k | ||
| R23 | 4k7 | 4.7k | ||
| R24 | 10k | 10k | ||
| R25 | 10k | 10k | ||
| Capacitors 23 | ||||
| C4 | 1n5 | 1.5n | ||
| C5 | 47p | 47p | ||
| C7 | 22n | 22n | ||
| C9 | 470p | 470p | ||
| C10 | 4n7 | 4.7n | ||
| C11 | 4n7 | 4.7n | ||
| C12 | 470p | 470p | ||
| C13 | 10n | 10n | ||
| C14 | 4n7 | 4.7n | ||
| C15 | 10n | 10n | ||
| C16 | 3n3 | 3.3n | ||
| C17 | 3n3 | 3.3n | ||
| C20 | 100n | 100n | ||
| C21 | 100n | 100n | ||
| C1 | 4u7 | 4.7u | ||
| C6 | 4u7 | 4.7u | ||
| C8 | 47u | 47u | ||
| C18 | 100u | 100u | ||
| C19 | 10u | 10u | ||
| C22 | 10u | 10u | ||
| C23 | 10u | 10u | ||
| C2 | 47p | 47p | ||
| C3 | 10n | 10n | ||
| Diodes 4 | ||||
| D1 | 1n5817 | 1N5817 | ||
| D2 | 3mm | 3MM | ||
| D3 | 1n5817 | 1N5817 | ||
| D4 | 1n5817 | 1N5817 | ||
| Transistors 3 | ||||
| Q1 | J201 | J201 | ||
| Q2 | J201 | J201 | ||
| Q3 | J201 | J201 | ||
| ICs 3 | ||||
| IC1 | NE5532 | NE5532 | ||
| IC2 | TL072 | TL072 | ||
| IC3 | TC1044SCPA | TC1044SCPA | ||
| Potentiometers 6 | ||||
| VOL | 50KA | A50k | Potentiometer | |
| SWEEP | 100KB | B100k | Potentiometer | |
| DRIVE | 500KA | A500k | Potentiometer | |
| MID | 10KB | B10k | Potentiometer | |
| PUSH | 10KB | B10k | Potentiometer | |
| TONE | 500KA | A500k | Potentiometer | |
| Trimmers 3 | ||||
| TRIM1 | 100K | 100k | Trimmer | |
| TRIM2 | 100K | 100k | Trimmer | |
| TRIM3 | 100K | 100k | Trimmer | |
| Jacks & sockets 1 | ||||
| J201 | Q1 | Q1 | ||
Other boards based on the JHS PG-14
- Blue Shoe Gai Pan Distortion PedalPCB · 125B · $12.00