Enclosure not stated
3PDT Wiring Board v6
- Category
- Other
- Price
- $0.79out of stock
From the vendor
Smallest profile only (.95″ x .93″) Amazingly useful for Combo Builds!
Description
Low Profile only (.95″ x .93″)
NOTE: These are not for NostalgiTone PCBs. Purchase NostalgiTone 3PDT Here
That is a small board (which is what you want) and will work with most any circuit. Fits over a standard solder lug foot switch and it is the only one that allows you to connect additional circuits, mod switches or LEDs inside the same enclosure with ease!!
The Board is labeled as follows:
• G Ground pads, five in total
• +9V +9V supply, four in total
• BI Wiring from the Main Circuit Board Input
• I Wiring from the Input Jack Tip
• O Wiring to the Output Jack Tip
• BO Wiring from the Circuit Board Output
• D1 Common Anode LED (Bi-Color) or Standard On/Off
• CLR Current Limiting Resistor – Use 1K8 (max Bright) to 4k7 (dim)
3PDT Wiring Board – Build Guide
Schematic
The schematic is in the vendor's build document, page 2. Open the build document. No KiCad fragment has been drawn for this circuit yet.
Parts list 3 rows
Report a wrong parseGot parts in a drawer? See what you can build with them.
| Ref | Value | Normalized | Type | Notes |
|---|---|---|---|---|
| Resistors 1 | ||||
| CLR | 1K8 | 1.8k | LED current limiting resistor: 1K8 (bright) to 4k7 (dim); read from the schematic by eye | |
| Switches 1 | ||||
| ×1 | 3PDT | 3PDT | foot switch soldered to the back of the board; read from the schematic by eye | |
| LEDs 1 | ||||
| D1 | LED | LED | common-anode bicolor or standard status LED; read from the schematic by eye | |