Splitter-Blend

From the vendor

Much requested, and finally we got around to it.

Run Off Groove's incredibly useful Splitter/Blend circuit takes your signal, splits it into two separate send-return paths and blends them back together at the end, in whatever ratio you dial in.

It does exactly what it says, and doesn't colour your tone in the process. If you run into phase issues when blending the signals there's a toggle switch to flip the phase of channel 1.

Only want one effects loop in your current set up? Simply add a jumper cable in one of the channels and you're blending your clean signal with the remaining loop.

Only one box option with this one. There's a zillion way's to lay this out in whatever box you want, but that's down to you.

If you want the PCBs without parts there's a link for that at the bottom of the page.

Partial kit: PCBs, all board-mounted components (not footswitches), pots.

Full kit: As above, plus footswitch and appropriate daughterboard/components for your selected bypass type (see Downloads section for details of those), jack sockets, DC socket, battery snap, hook-up wire, LED.

Enclosure (pre-drilled) is available as an option with full kits, and will not take a battery. Knobs are not included.

Builds are only available with full kits including enclosures. Please choose appropriate knobs.

Inspired by: RunOffGroove Splitter-Blend

Difficulty: Medium

PCB size: 50 x 40mm

Knobs required: 1

Enclosure: 1590BB

Download the INSTRUCTION PDF