OD-1 / FullTilter

From the vendor

Jump in your way-back-when machine and ride that overdriven wave.

The OD-1 needs no introduction - or explanation - surely? It's the birth of the box of drive and sounds just as good as in it's heyday. We've had to substitute the op-amp and diodes as the originals are long since obsolete, but there's nothing magical about them.

If you want a little more control than your Gain and Vol pots, you can go for the boutique FullTilter build, which adds toggle switches for Edge (treble boost) and Bottom (bass boost). There's no downside, so go for it.

Supplied with board-mounted pots with round shafts, so you'll need set-screw fitting knobs).

If you want the PCB without parts there's a link for that at the bottom of the page.

Partial kit: PCB, all board-mounted components, pots.

Full kit: As above, plus footswitch and appropriate daughterboard/components for your selected bypass type (see Downloads section for details of those), jack sockets, DC socket, battery snap, hook-up wire, LED.

Enclosure (pre-drilled) is only available with full kits, and will take a battery if desired, with the footswitch positioned 22mm closer to the pots.. Knobs are not included.

Builds are only available with full kits including enclosures. Please choose appropriate knobs.

Inspired by: OD-1 / Fulltender

Difficulty: Medium

PCB size: 50 x 40mm

Knobs required: 2

Enclosure: 1590B

Direct Connect compatible (4 way)

Download the INSTRUCTION PDF