Country Crunch Drive

From the vendor

Don't let the name fool you. This signature pedal of a well known country slinger is so versatile it could sit on any board. From almost clean boost, through a bit of hair, to all out screaming solo drive, this box has it all while keeping its composure (and your tonal integrity). Your standard Volume, Gain and Tone (we'll get to that shortly) controls are augmented by a prescence switch to make it sounds as good with your Tele as it does with your LP. Add to that the three way mids switch and you have countless settings to play with. The original uses a C25K pot for the Tone control, and try as we might we can't grab any in vertical pin format. We've spent a long time trying it with every different combo of pot value and tapering resistor, and the best workaround we've found is simply C50K with a 51K resistor across pins 1 and 3. There's still a little bunching at the extreme ends of the turn, but it's a very useable work-around. If you don't fancy that, don't buy it. The kit is supplied with vertical-mount pots which have round shafts, so you'll need set-screw fitting knobs. If you want the PCB without parts there's a link for that at the bottom of the page. Partial kit: PCB, all board-mounted components, pots. Full kit: As above, plus footswitch and appropriate daughterboard/components for your selected bypass type (see Downloads section for details of those), jack sockets, DC socket, battery snap, hook-up wire, LED. Enclosure (pre-drilled) is available as an option with full kits, and will not take a battery. Knobs are not included. Builds are only available with full kits including enclosure and vertical-mount pots. Please choose appropriate knobs. Inspired by: Paisley Drive Difficulty: Medium PCB size: 50 x 50mm Knobs required: 3 Enclosure: 1590B Direct-Connect compatible (4-way) Download the INSTRUCTION PDF