Clapton Mid Boost

From the vendor

NOTE: this has unavoidable switch pop. Consider it an always-on effect.

----------------

Clap your hands and say 'Mids'! Clap them hard enough and you may hit 25dB's worth.

The on-board Clapton mids circuit squeezed into a pedal so you can use it on anything, not just your strat. Mids boost from 0 - 25dB on tap to fatten things up as much or as little as required.

There are some pretty funky resistor values in this circuit, but we've got you covered. Would you expect anything less?

The kit is supplied with vertical-mount pots which have round shafts, so you'll need set-screw fitting knobs.

If you want the PCB without parts there's a link for that at the bottom of the page.

Partial kit: PCB, all board-mounted components, pots.

Full kit: As above, plus footswitch and appropriate daughterboard/components for your selected bypass type (see Downloads section for details of those), jack sockets, DC socket, battery snap, hook-up wire, LED.

Enclosure (pre-drilled) is available as an option with full kits, and can take a battery if desired with footswitch positioned 22mm higher, closer to the controls. Knobs are not included.

Builds are only available with full kits including enclosure and vertical-mount pots. Please choose appropriate knobs.

Inspired by: Clapton's on-board mid boost

Difficulty: Easy

PCB size: 50 x 30mm

Knobs required: 2

Enclosure: 1590B

Direct-Connect compatible (4-way)

If you want the kit pre-built you must add the enclosure option below and select your knobs in the Components section. Check Specials for powder-coated enclosure availability.

Download the INSTRUCTION PDF