Akashic Guitar effects circuit lookup

Enclosure not stated

Effects Layouts (blog)

Demedash Effects Incandenza BypassVerified

Based on the Demedash Effects Incandenza Relay Bypass· 1 other board clones it

Category
Utility
Layout
Verified · Effects Layouts (blog) marks it as built and working
Tags
Utility

From the post

The Incandenza Bypass is a simple, low parts count, relay-based true bypass circuit designed by Steve Demedash. It uses a normally open momentary SPST footswitch triggering a simple 555-based flip flop circuit, triggering a non-latching DPDT footswitch. The layout below reflects the pinout of the either the Takamisawa NA5W-K or Omron G6S-2 relays. These are 2 relays I had in my parts stash that worked with the circuit when I breadboarded it and are both rated at 5v. Other non-latching relays can be used, but double check the pinouts and compare datasheets. Schematic can be found here.

Note: Send goes to the effect input, Return goes to the effect output, In goes to the input jack, and Out goes to the output jack.

Schematic

This is a board layout, a drawing of where each part goes, and the post may link the schematic it was drawn from. Open the layout at Effects Layouts (blog). No KiCad fragment has been drawn for this circuit yet.

Parts list 9 rows

Report a wrong parse

Got parts in a drawer? See what you can build with them.

RefValueNormalizedTypeNotes
Resistors 3
×210K10kread from the layout by eye
×1100K100kread from the layout by eye
×1330Ω330read from the layout by eye
Capacitors 1
×11uF1uelectrolytic; read from the layout by eye
Diodes 1
×21N40011N40011N4001; read from the layout by eye
ICs 1
×1555555read from the layout by eye
Switches 1
SwSPSTSPSTnormally open momentary; the footswitch; read from the layout by eye
LEDs 1
×1LEDLEDon the board; read from the layout by eye
Other 1
×1non-latching DPDT relayNON-LATCHING DPDT RELAYrelay; read from the layout by eye

Other boards based on the Demedash Effects Incandenza Relay Bypass