Akashic Guitar effects circuit lookup
INPUTGAINTONEVOLUME

Enclosure not stated · 4 knobs

Effects Layouts (blog)

Apocalypse Audio ThundertoneVerified

Based on the Apocalypse Audio Thundertone· 3 other boards clone it

Category
Fuzz
Controls
Input · Gain · Tone · Volume
Layout
Verified · Effects Layouts (blog) marks it as built and working
Tags
Apocalypse Audio, Fuzz, Overdrive

From the post

Fuzz Friday! Here's a cool fuzz based on the old Supro Thunderbolt amp using NPN germanium transistors by RnFR from the Apocalypse Audio blog. Here's what he had to say about it:

I have been thinking about modeling the Supro Thunderbolt with FETs, but then thought- I just got in these cool new Tesla GE's, why not use those? So that's what it is, the preamp section of the legendary amp used by Page and supposedly Hendrix, done up NPN germanium style. I had to eliminate a few resistors towards the end to bring up the volume and lowered the value of an emitter resistor to up the gain a bit. Also, I made the resistor on the input variable so you can adjust the input impedance for guitars with different pickups.The real gem of this circuit is the tone pot- totally counter-clockwise you get a nice full range tone with plenty of mids. As you go clockwise it goes to a very muffled tone, and as you go even further, it goes to a very thin, cutting tone. There are some very cool sweet spots, and a lot of versatility. I like it better than a regular muff style control, but it does cut plenty of signal- hence the two gain stages after it.It's a cool sounding circuit. Nicely voiced and does a good overdrive type sound. If you don't have the trannys, you could change out the 33K Rc's to trimmers and adjust to taste. The Tesla trannies are extremely consistent, so no trimmers needed.

Here's the schematic for reference.

Schematic

This is a board layout, a drawing of where each part goes, and the post may link the schematic it was drawn from. Open the layout at Effects Layouts (blog). No KiCad fragment has been drawn for this circuit yet.

Parts list 23 rows

Report a wrong parse

Got parts in a drawer? See what you can build with them.

Check before you build · 1 value the reader of this layout was not sure of
  • 3nF at C/I-K (top centre): printed clearly, unusual value
RefValueNormalizedTypeNotes
Resistors 9
×11K1kread from the layout by eye
×1150K150kread from the layout by eye
×31M1Mread from the layout by eye
×1100K100kread from the layout by eye
×22.2K2.2kread from the layout by eye
×333K33kread from the layout by eye
×147Ω47read from the layout by eye
×13.3M3.3Mread from the layout by eye
×1270K270kread from the layout by eye
Capacitors 6
×13nF3nread from the layout by eye
×21nF1nread from the layout by eye
×347nF47nread from the layout by eye
×14.7nF4.7nread from the layout by eye
×222uF22uelectrolytic; read from the layout by eye
×147uF47uelectrolytic; read from the layout by eye
Diodes 1
×11N40011N4001read from the layout by eye
Transistors 3
Q1103NU71103NU71or similar NPN germanium; read from the layout by eye
Q2103NU71103NU71or similar NPN germanium; read from the layout by eye
Q3103NU71103NU71or similar NPN germanium; read from the layout by eye
Potentiometers 4
InputB50KB50kPotentiometerread from the layout by eye
GainA500KA500kPotentiometerread from the layout by eye
ToneB500KB500kPotentiometerread from the layout by eye
VolumeA100KA100kPotentiometerread from the layout by eye

Other boards based on the Apocalypse Audio Thundertone