1590B · 3 knobs
Death by Audio Reverberation MachineVerified
Based on the Death By Audio Reverberation Machine· 7 other boards clone it
From the post
Here's a cool dirty reverb effect by Death by Audio. It uses a Belton brick like many other designs, and offers clean reverb with the gain control turned all the way down. But when you increase the gain, fuzz is infused to the signal. You can mount the Belton brick to the board from the solder-side (best to do this once the rest of the board has been populated). It'll probably be too tall with the brick to fit in a 1590B, but a 125B should work just fine.
Schematic
This is a board layout, a drawing of where each part goes, and the post may link the schematic it was drawn from. Open the layout at Effects Layouts (blog). No KiCad fragment has been drawn for this circuit yet.
Parts list 24 rows
Report a wrong parseGot parts in a drawer? See what you can build with them.
Check before you build · 1 value the reader of this layout was not sure of
- Switch: legend says only 'DPDT', wired to pads Sw1-Sw6; taken as an effect switch rather than the bypass
| Ref | Value | Normalized | Type | Notes |
|---|---|---|---|---|
| Resistors 8 | ||||
| ×5 | 100K | 100k | read from the layout by eye | |
| ×4 | 10K | 10k | read from the layout by eye | |
| ×7 | 1M | 1M | read from the layout by eye | |
| ×1 | 1K | 1k | read from the layout by eye | |
| ×1 | 22K | 22k | read from the layout by eye | |
| ×2 | 39K | 39k | read from the layout by eye | |
| ×1 | 6.8K | 6.8k | read from the layout by eye | |
| ×1 | 68K | 68k | read from the layout by eye | |
| Capacitors 8 | ||||
| ×2 | 470pF | 470p | read from the layout by eye | |
| ×1 | 4.7nF | 4.7n | read from the layout by eye | |
| ×2 | 10nF | 10n | read from the layout by eye | |
| ×2 | 33nF | 33n | read from the layout by eye | |
| ×2 | 100nF | 100n | read from the layout by eye | |
| ×3 | 220nF | 220n | read from the layout by eye | |
| ×3 | 1uF | 1u | electrolytic; read from the layout by eye | |
| ×2 | 100uF | 100u | electrolytic; read from the layout by eye | |
| Diodes 1 | ||||
| ×1 | 1N4001 | 1N4001 | read from the layout by eye | |
| ICs 2 | ||||
| ×1 | TLC27M4ALN | TLC27M4ALN | read from the layout by eye | |
| ×1 | 7805 | 7805 | regulator, drawn 'I G O' on the board, named 7805 in the wiring diagram; read from the layout by eye | |
| Potentiometers 3 | ||||
| Blend | A10K | A10k | Potentiometer | read from the layout by eye |
| Gain | C1M | C1M | Potentiometer | read from the layout by eye |
| Volume | A100K | A100k | Potentiometer | read from the layout by eye |
| Switches 1 | ||||
| Switch | DPDT | DPDT | Sw1-Sw6; read from the layout by eye | |
| Other 1 | ||||
| ×1 | BTDR-2H-L | BTDR-2H-L | reverb module, pins 1-6; read from the layout by eye | |
Other boards based on the Death By Audio Reverberation Machine
- Death by Audio Reverberation Machine Dirtbox Layouts
- Verb Engine Fuzz Dog · 1590BB · £42.00
- Verb Engine - Feedbacker Fuzz Dog · 1590BB · £48.00
- Space Is Fun Moonn Electronics · €6.50
- Death by Reverb PCB Guitar Mania · 125B · €11.90
- Death by Reverb SMD PCB Guitar Mania · 125B · €21.90
- Death By Audio Reverberation Machine Tagboard Effects