Double Cross

From the vendor

This is our take on a dual Rat project. Yes... that's right. If you thought two Rat's under the same roof only happens in prisons, think again! What separates this from any other Rat project available on the WWW is that we have managed to source a limited supply of LH2108 chips. It's two LM108's combined into a single IC package. The LM108 is the MIL-Spec version of the LM308, the bigger, tougher brother of the LM308 if you will. Same performance spec's, but higher tolerance ratings. If your next gig is going to be anywhere near flying beer bottles, rambunctious lead singers, or cluster bombs, this chip will take what you can dish out.

Each project will include;

A) One (1) beautifully appointed black PCB. While the two circuits are totally separate, they both run through a single LH2108. You can run them individually, in stereo, or if your cheese happens to slide off your cracker, in series. Both sides offer the standard controls found on any Rat, but there are additional gain and clipping options found on both sides, which include; Various post clipping options (germanium/silicon/LED) on both sides. - Feedback loop clipping options (MOSFET/germanium, LED, or none) on side B. - Turbo mode post resistors option on side A, and finally - Reutz mod gain adjust on both sides. - Millennium II bypass switching on both sides.

B) One (1) LH2108. This will run until our limited supply of LH2108 is exhausted. There is so much mojo oozing out of this chip, it sounds good just looking at it.

C) Tracked shipping worldwide. DUE TO THE RARITY AND COST OF THE LH2108, SHIPPING FOR THIS PACKAGE ONLY WILL BE TRACKED WORLDWIDE, HENCE THE ADDED SHIPPING EXPENSE. WE WILL NOT SHIP THESE VIA OUR REGULAR PARCEL MAIL SERVICE.

DISCLAIMER!!! (Please read carefully, absorb into your brain, and understand...)

- Availability of this project is wholly dependent on LH2108 supply. - Each LH2108 is physically tested for complete operational performance before they are shipped. This is done using our own validation build as the test bench. Once they are shipped however, we are no longer responsible for them. They will be shipped using proper formed anti-static plastic IC packaging. - Because this is a board and IC package, additional packaging requirements are necessary. As such, apart from our general shipping policies, additional handling costs are applicable. - We cannot stress this enough... WE DO NOT HAVE EXTRA LH2108's KICKING AROUND! So, if you mess it up... it's your problem.